We are often asked about the weight and sink rate of poly leaders, so we thought it might be a good idea if we compiled a table for you to refer to:

The weights are for AirFlo Poly Leaders only and may vary slightly due to manufacturing tolerances.
To complete the picture we have also compiled a chart of the CCT’s (custom cut tips).
Looking at the two charts and in particular the sink rates of the PolyLeaders, you can see that the sink rate of an Extra Super Fast PolyLeader @ 6.1 ins / sec is just below that of a T7 @ 7ins / sec.
Very informative
Thanks Michael – glad you think so.
Thanks Michael, glad you found it useful…